Paired with the TAKER H65_8S_BLS 65A 4IN1 ESC, providing a smooth flying experience
Simple and efficient installation method with shock absorbers for stable gyroscope performance
Dual independent BECs: 9V@2.5A and 5V@3A
SpecificationsGEP-F722-HD v2 Flight Controller
MCU: STM32F722
IMU: ICM42688-P(SPI)
Air Unit Connection: Direct plug-in to DJI Air Unit
Black Box:16M onboard
USB Interface: Type-C
Barometer: supported
OSD: BetaFlight OSD w/ AT7456E chip
BEC: 5V@3A,9V@2.5A dual BEC
Firmware Target: GEPRCF722
Dimension: 36.85×36.85mm, mounting hole size 30.5×30.5mm，φ4mm hole becomes φ3mm after using a silicone shock-absorbing circle.
Input Voltage: 3-6S LiPo
UART: 5
Power Filter: Integrated LC filter
Weight: 8.1g
TAKER H65_8S_BLS 65A 4IN1 ESC
Input Voltage: 3-8S Lipo
Ammeter: Supported
Continuous Current：65A
Burst Current：70A（5 seconds）
Support Protocol: Dshot 150/300/600
Dimension：42×45.7mm,mounting hole size30.5×30.5mm，φ4mm hole becomes φ3mm after using the silicone shock-absorbing ring.
Weight: 14.9g
Firmware Target: B_X_30
Includes 1 x FC board 1 x ESC board 1 x Capacitor 1 x DJI Air Unit adapter cable 1 x Flight controller adapter cable 1 x XT60 power cable 4 x M3*30 screws 4 x M3*25 screws 8 x Nylon nuts 8 x Silicone anti-shake pads 2 x sh1.0 4pin silicone cable 1 x Camera connection cable